3B SMART KEY motor disconnect device
A temperature sensor disconnects the motor when the water temperature inside the motor rises to a certain degree. It has a copper column that conducts heat quickly, and it has a dial to control the degree of separation from 0 to 60 degrees Celsius. It protects the motor from damage
SECURITY

Auto-arm

After ignition off, it will be automatically system armed.

The unique indification.

The unique data will be wrote into the smart card, and it is not allowed to be amended to make sure of the possibility of unique indification.

The concealed sensing place.

The sensing antenna installed in a concealed place.

Everlasting of smart card.

No need battery inside the card and static-current proof to make sure the everlasting of smart card.

Anti code scanning.

The valid sensing distance is less then 5 cm to avoid code scanning to discode the system
FEATURES

Disarm

When the legal owner with the identification card closes to the sensor, the buzzer will “Di Di” twice continuously to indicate the system disarmed. The LED indicator will be off and the car can be operated normally.

Auto-arm

After system disarmed, the car engine must be started within 25 seconds. For security, the system will “Di”once to enter arm status again in 25 seconds. Then the system should be disarmed again to start the car engine.

Power off memory

When power off and on again, no matter how long it lasts, the system will automatically restore to the status before power off.

5. Trigger alarming

In arm, if system is triggered such as ignition started illegally, after 8 seconds the buzzer will beep and the LED indicator will flash quickly until the system disarmed or no trigger again after beep 30 seconds.

Master code matching

Press the code learning switch, the LED indicator will on for 10 seconds, put the card close to the sensor, then “Di” once to indicate code matching successfully. Only one master card can match the code

المواصفات الرئيسية

3B SMART KEY motor disconnect device
A temperature sensor disconnects the motor when the water temperature inside the motor rises to a certain degree. It has a copper column that conducts heat quickly, and it has a dial to control the degree of separation from 0 to 60 degrees Celsius. It protects the motor from damage